Slingbox Pro SB200-XXX power supply failure

The 230V connector on this unit was attached to those jumpers at the edge of the board. They require desoldering before the board can be removed.

Ktec AC adaptor, manufactured in 2007 (assumed), model no. KSA0600350W1UV-1

C12, C13 and C14 had failed. C12 and C13 are connected directly in parallel, and were CapXon GF at 16V and 680µF each. C14 was also a CapXon GF, but at 16V/220.

C12 and C13 were successfully collectively replaced by one recycled 16V/1500µF Chemi-Con KZG. C14 was successfully replaced by one 50V/100µF Nichicon PS.

The solder joints for the three-legged component beside C12 were not failed, but very poor. I recommend re-doing them at the same time.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s